Skip to content

Engine Horsepower Calculator

Use a drag strip time slip to estimate how much power your car makes.

Science & EngineeringUpdated Free · No sign-up

How to use the Engine Horsepower Calculator

  1. Pick what you want to work out using the tabs: From ¼-mile ET or From trap speed.
  2. Enter Vehicle weight with driver and choose its unit.
  3. Enter ¼-mile elapsed time.
  4. Read your answer in the results panel. It updates as you type, and the breakdown, step-by-step working and any charts or tables appear below it.
  5. Use Share link to save or send the exact calculation, or Copy to paste the results elsewhere.

How it works

A quarter-mile pass is a simple physics test. The car’s weight is known, the distance is fixed at 1,320 ft, and the time slip records how long the run took and how fast the car was going at the end. Racers worked out empirical formulas from many real runs that link these numbers to engine power.

The formulas

The elapsed-time method, often credited to Roger Huntington and popularised by Patrick Hale:

HP = weight ÷ (ET ÷ 5.825)3

The trap-speed method:

HP = weight × (trap speed ÷ 234)3

Weight is in pounds, including the driver and fuel. ET is in seconds and trap speed is in mph. Both formulas use a cube because the power needed rises with the cube of speed for a given weight.

Worked example

A 3,500 lb car (with driver) runs a 12.5-second quarter mile:

  • 12.5 ÷ 5.825 = 2.146
  • 2.1463 = 9.882
  • HP = 3,500 ÷ 9.882 ≈ 354 hp

If the same car trapped at 110 mph, the trap-speed formula gives 3,500 × (110 ÷ 234)3 ≈ 364 hp. The calculator also shows the trap speed you would expect from the ET result and the ET you would expect from the trap speed. A big gap between the two usually points to a poor launch.

Which method is more reliable?

Trap speed is usually the better guide. ET depends heavily on the launch: wheelspin, a slow shift or a bad reaction off the line can add several tenths without saying anything about the engine. Trap speed is measured at the end of the run, after the car has been accelerating hard for most of the distance, so it tracks power more closely.

Caveats

  • These are estimates of engine (flywheel) power for a typical rear-wheel-drive street car. Results can be 10% or more off for unusual cars.
  • Aerodynamics, gearing, tyres and drivetrain losses all affect the numbers.
  • Air density matters. Hot, humid or high-altitude days make cars slower, so compare runs using weather-corrected times when you can.
  • Weigh the car at the track with the driver aboard if possible. A 100 lb error changes the estimate by about 3%.

Frequently asked questions

How do I calculate horsepower from a quarter-mile time?

Divide the ET by 5.825, cube the result and divide the car’s weight in pounds by that number. A 3,500 lb car running 12.5 seconds makes about 354 hp.

Is this flywheel or wheel horsepower?

The formulas were fitted to engine (flywheel) ratings, so treat the result as an estimate of crank horsepower. Wheel horsepower is typically 10–20% lower.

Should I include the driver in the weight?

Yes. Use the full race weight: car, driver, fuel and anything else on board during the run.

Why do the ET and trap-speed answers differ?

ET is affected by traction and launch technique, while trap speed reflects power more directly. If the ET estimate is much lower, the car is probably losing time off the line.