Skip to content

Ohm’s Law Calculator

Type in any two values (volts, amps, ohms or watts) and leave the other two blank.

Science & EngineeringUpdated Free · No sign-up

How to use the Ohm’s Law Calculator

  1. Add any optional details you have; leave the rest blank.
  2. Read your answer in the results panel. It updates as you type, and the breakdown, step-by-step working and any charts or tables appear below it.
  3. Use Share link to save or send the exact calculation, or Copy to paste the results elsewhere.

Ohm’s law and the power law

Ohm’s law says that the current through a conductor is proportional to the voltage across it. The constant linking them is resistance:

V = I × R

Electrical power is the rate at which energy is delivered, and it equals voltage times current:

P = V × I

Combining these two equations lets you find all four quantities from any two of them. That gives twelve formulas, often drawn as a wheel with V, I, R and P in the four quarters.

To find Formulas
Voltage V I × R, P ÷ I, √(P × R)
Current I V ÷ R, P ÷ V, √(P ÷ R)
Resistance R V ÷ I, V² ÷ P, P ÷ I²
Power P V × I, I² × R, V² ÷ R

Worked examples

LED resistor: a 12 V supply drives 0.5 A through a load. R = 12 ÷ 0.5 = 24 Ω and P = 12 × 0.5 = 6 W.

Resistor power rating: a 100 Ω resistor rated at 0.25 W. The most current it can safely carry is √(0.25 ÷ 100) = 0.05 A (50 mA), and the most voltage across it is √(0.25 × 100) = 5 V.

Kettle: a 2,000 W kettle on 230 V draws 2,000 ÷ 230 = 8.7 A, and its element has a resistance of 230² ÷ 2,000 = 26.45 Ω when hot.

Units and prefixes

Results are shown with engineering prefixes so they are easy to read: mA (milliamps, thousandths of an amp), kΩ (kilohms, thousands of ohms), µA (microamps), MΩ (megohms) and so on. Enter plain base units: volts, amps, ohms and watts. For example, type 0.02 for 20 mA.

When Ohm’s law doesn’t apply directly

  • Diodes, LEDs and transistors are non-linear: their resistance changes with voltage, so use their datasheet curves.
  • Filament lamps and heaters have a much lower resistance when cold than when hot.
  • In AC circuits with motors or capacitors, use impedance instead of resistance and include the power factor when finding real power.

For DC circuits and purely resistive AC loads such as heaters, the formulas here are exact.

Frequently asked questions

What is Ohm's law?

Ohm’s law states that voltage equals current times resistance (V = I × R). Double the voltage across a fixed resistor and the current doubles too.

How do I calculate watts from volts and amps?

Multiply them: watts = volts × amps. A device drawing 2 A at 120 V uses 240 W.

How do I calculate amps from watts and volts?

Divide watts by volts. A 1,500 W heater on 120 V draws 12.5 A.

Can I use Ohm's law for AC circuits?

Yes for purely resistive loads such as heaters and incandescent bulbs. For motors and electronics, use impedance and include the power factor.